Browsing by Author "Colegrove, Paul"
Now showing 1 - 7 of 7
Results Per Page
Sort Options
Item Open Access 3D modelling of Ti-6Al-4V linear friction welds.(Cranfield University, 2016-11-28 08:49) McAndrew, Anthony; Colegrove, Paul; Buhr, ClementExperimental data set from the article "3D modelling of Ti-6Al-4V linear friction welds"Please see the introduction tab in the excel file for further details.Item Open Access Data for the paper "residual stress and texture control in Ti-6Al-4V wire + arc additively manufactured intersections by stress relief and rolling"(Cranfield University, 2018-05-02 13:58) roman Hönnige, Jan; Ganguly, Supriyo; Colegrove, Paul; Williams, Stewart; Lik Lee, Tung; Fitzpatrick, Michael; Ahmed, BilalData supporting the paper: "residual stress and texture control in Ti-6Al-4V wire + arc additively manufactured intersections by stress relief and rolling".Item Open Access Data underpinning "Interpass Rolling of Ti-6Al-4V Wire + Arc Additively Manufactured Features for Microstructural Refinement"(Cranfield University, 2018-02-19 16:44) Colegrove, Paul; McAndrew, AnthonyData set for grain size graphs.Item Open Access Data Underpinning "Weld-Bonded Stainless Steel to Carbon Fibre-Reinforced Plastic Joints"(Cranfield University, 2017-09-07 15:26) Colegrove, Paul; Joesbury, Adam; Ayre, David; Van Rymenant, Patrick; Ganguly, Supriyo; Williams, StewartFigures for article entitled "Weld-Bonded Stainless Steel to Carbon Fibre-Reinforced Plastic Joints"Item Open Access Data underpinning “Investigation of post-weld rolling methods to reduce residual stress and distortion”(Cranfield University, 2017-04-27 08:52) Colegrove, Paul; Cozzolino, DanielData set containing the results from models that predict residual stress and distortion after rolling.Item Open Access Influence of shielding gas nozzle design on power density distribution in low-current TIG welding arcs(Springer, 2020-03-17) Egerland, Stephan; Colegrove, Paul; Williams, StewartShielding gas nozzle diameter variation and its impact on the anodic power distribution of low-current tungsten inert gas arcs were investigated, while maintaining either shielding gas flow rate or flow velocity constant. In addition, the effects of anode surface condition and flow behaviour type (laminar or turbulent) caused by the shielding gas nozzle applied were studied. It was found that arcs of 50 amperes (A) welding current were highly unstable deploying the conditions used, while increasing the arc electrical current to 100 A led to improved arc stability. As found in previous investigations, non-Gaussian distribution profiles occurred at 50 A, even with improved shielding. The power density maxima were found shifted away from the arc axisItem Open Access Modelling of the workpiece geometry effects on Ti-6Al-4V linear friction welds - open access data(Cranfield University, 2016-05-06 14:33) McAndrew, Anthony; Colegrove, Paul; Addison, Adrian; Flipo, Bertrand; Lee, Lucie; Russell, MichaelExperimental data set from the article "Modelling of the workpiece geometry effects on Ti-6Al-4V linear friction welds"Please see the introduction tab in the excel file for further details.