Browsing by Author "Li, Yushuai"

Now showing 1 - 2 of 2
  • Thumbnail Image
    ItemOpen Access
    Aerodynamic analysis of a flapping wing aircraft for short landing
    (MDPI, 2020-05-14) Ji, Bing; Zhu, Zenggang; Guo, Shijun; Chen, Si; Zhu, Qiaolin; Li, Yushuai; Yang, Fan; Song, Rui; Li, Yibin
    An investigation into the aerodynamic characteristics has been presented for a bio-inspired flapping wing aircraft. Firstly, a mechanism has been developed to transform the usual rotation powered by a motor to a combined flapping and pitching motion of the flapping wing. Secondly, an experimental model of the flapping wing aircraft has been built and tested to measure the motion and aerodynamic forces produced by the flapping wing. Thirdly, aerodynamic analysis is carried out based on the measured motion of the flapping wing model using an unsteady aerodynamic model (UAM) and validated by a computational fluid dynamics (CFD) method. The difference of the average lift force between the UAM and CFD method is 1.3%, and the difference between the UAM and experimental results is 18%. In addition, a parametric study is carried out by employing the UAM method to analyze the effect of variations of the pitching angle on the aerodynamic lift and drag forces. According to the study, the pitching amplitude for maximum lift is in the range of 60°~70° as the flight velocity decreases from 5 m/s to 1 m/s during landing.
  • Thumbnail Image
    ItemOpen Access
    Design and experiment of a bionic flapping wing mechanism with flapping–twist–swing motion based on a single rotation
    (AIP Publishing, 2020-06-12) Ji, Bing; Zhu, Qiaolin; Guo, Shijun; Yang, Fan; Li, Yushuai; Zhu, Zenggang; Chen, Si; Song, Rui; Li, Yibin
    In the present study, a bionic flapping mechanism of a spatial six-bar configuration was designed to transform a single rotation of a motor into a three degrees of freedom “flapping–twist–swing” cooperative motion of a flapping wing. The kinematics model of the flapping mechanism movement was constructed. The flapping trajectory of the wing based on the kinematics model was to mimic the motion of a pigeon wing in landing flight. To reduce the manufacturing complexity, the flapping mechanism was simplified with only two degrees of freedom (flapping and twist) retained. Finally, a prototype model with a 0.9 m wing span was built and tested. A comparison among the experimental data, theoretical calculation results, and ADAMS simulation results revealed that the difference in the flapping and the twist amplitude between experimental observations and theoretical calculation results was 12.5% and 2.3%, respectively. This was owing to the elastic deformation of the bar and the mechanism simplification. The comparison results also indicated that the maximum difference in the inertial force was 5.9% in up-stroke and 6.7% in down-stroke, respectively. The experimental results showed that the inertial force of the model with the wing patagium was approximately 2.2 N, and the maximum positive and negative lift was 2.1 N and −1.5 N, respectively. It is hoped that this study can provide guidance for the design of bionic flapping wing mechanisms of a flapping wing aircraft for short landing flight.